Ä«µå¿Í µð½ºÇ÷¹ÀÌ ¸ðµÎ ÀÌ¹Ì »çÀü ¼³Ä¡µÈ Æß¿þ¾îÀÔ´Ï´Ù.
Parameter of control board:
Connection: USB (USB-CH340)
Software: GRBL controller, Universal Gcode Sender
Master chip: atmel 328P
Stepper motor driver: A4988
Spindle drive chip: MOSFET, the highest 60V (recommendation within 48V, current :within 10A )
Support stepper motor: 12V, maximum current of 2A or less is recommended within 1.5A and additional heat. (Any stepper motor 42, 57)
Laser engraving: Support
Specification of offline controller:
Press Z+ and Z- , the Z axis will move up and down.
Press X+ and X- , the X axis will move left and right.
Press Y+ and Y- , the Y axis will move Front and Back.
Press SPIN: Spindle on (Laser on), Spindle off (laser off)
Press SMOD: return
Press Z+ for 5 seconds, change the Language to English.
Name:CNC TFT24 Display
Wiring
Size
How to Use
Firmware Download and Update
https://github.com/Macrobase-tech/CNC-Firmware
1. Install Xloader to PC,upload GRBL firmware to CNC board.
Select baud rate 115200.
2. Display firmware update
Select baud rate 115200.
Copy below files to SD card and plug it to TFT24 display.
3.Wire TFT24 to Aux-1 of CNC board.Then put board`s power on,it will update automatically.
4. Read G-code
Copy G-code to SD card,plug it to the display.(SD card:1g-16g,Gcode format is nc.)
How to Use WIFI.
1.Connect to your WIFI.Enable WIFI on TFT config.And update the firmware to display.
2.Install MKSLaser APP to Phone.