Features:
1.Physical Dot by Dot display.
2.Touch to adjust the brightness.
3.Support the brightness memory function,and can adjust the partial display window.
4.At the lowest brightness, the kit power consumption is 0.15w
5.Use the lower screen of DSI to transfer, 240*160 display.
6.The LCD screen picture size is the same to the original screen, so the screen lens can be universal.
7.Comes with the cables and support two different motherboards (32pin and 40pin) at the same time. both can support.
Package Included:
1x LCD Screen
1x Ribbon Cable
1x 32pin Ribbon Cable
1x 40pin Ribbon Cable
1x Welding Wires
1x Shading Sticker
1x 3M Self-adhesive Sticker
Detailed Installation Steps(Combined with the detailed picture below):
1.Before installing the LCD Kits, make a lighting test.
2.Open the clip in the direction indicated by the black arrow.
3.Insert the ribbon cable and buckle the clip.
4.Install the battery in the back cover, power on and test the screen.
5.At the same time, test the touch adjustment brightness whether it is normal.
6.Remove the protective film of the LCD screen (Don`t throw it away);
7.Take out the shading sticker;
8.Tear off the shading sticker, the glue side is facing up, and the screen is pasted as shown in the figure;
9.Fold the four sides of the shading sticker and paste it;
10.Trim the screen protective film fine and stick it on the back of screen;
11.Fold the screen cable like this in advance;
12.These places need to be modified and removed
Customized IPS shell: The Red traced part needs to be cut
Original shell: The Blue traced part needs to be cut.
13.Put the 3M sealant on the shell first.
14.Lean on the top and left sides of the shell , to stick the screen fine in the shell with installed cables.
15.Welding just adds a screen position adjustment function
(The screen can be used normally even without welding).
16.The three welding wires are respectively welding these three points.
17.After soldering, make the large ribbon cable and the touch ribbon cable are connected, and the touch area is folded upward.
18.Fold it and put it inside the front shell.
19.Install the buttons on the side, install the screws, attach the screen lens, and done it fine fianlly.
![](https://ae01.alicdn.com/kf/S447e1d00dfeb46e597d828145b79a129T.jpg)
![](https://ae01.alicdn.com/kf/Sfdd9d4c6ca784dcfbb599027cd3a75172.jpg)
![](https://ae01.alicdn.com/kf/Sf0d52b6199da455493f191f8b2fe56d81.jpg)
![](https://ae01.alicdn.com/kf/Sa3112ad23379466a95654c11c3847764t.jpg)
![](https://ae01.alicdn.com/kf/S187c7a9083a2404087828ef186f245d6t.jpg)
![](https://ae01.alicdn.com/kf/S1dbe4c8fb83c4ef1932a08db11b283cbx.jpg)
![](https://ae01.alicdn.com/kf/S8cef29855a4043c49a8a0201baa376b4a.jpg)
![](https://ae01.alicdn.com/kf/S07e01a7bafb04d46a1cbdd301aec7091G.jpg)
![](https://ae01.alicdn.com/kf/Sd8958607c8c949e095462ce71cb693eaJ.jpg)