The ESP32-S3-DevKitC-1 is an entry-level. development board equipped with either ESP32-S3-WROOM-1, a general-purpose Wi-Fi + Bluetooth¢ç LE MCU module that integrates complete Wi-Fi and Bluetooth LE functions.
Most of the I/O pins on the module are broken out to the pin headers on both sides of this board for easy interfacing.
Developers can either connect peripherals with jumper wires or mount ESP32-S3-DevKitC-1 on a breadboard.
Key Component Description They provide acceleration for neural network computing and signal processing workloads. ESP32-S3-WROOM-1 comes with a PCB antenna.
5 V to 3.3 V LDO Power regulator that converts a 5 V supply into a 3.3 V output. Pin Headers All available GPIO pins (except for the SPI bus for flash) are broken out to the pin headers on the board for easy interfacing and programming.
USB-to-UART Port A Micro-USB port used for power supply to the board, for flashing applications to the chip, as well as for communication with the chip via the on-board USB-to-UART bridge.
Boot Button Download button.
Holding down Boot and then pressing Resetinitiates Firmware Download mode for downloading firmware through the serial port.
Reset Button Press this button to restart the system.
USB-to-UART Single Bridge USB-to-UART bridge chip provides transfer rates up to 3 Mbps.
RGB LED Addressable RGB LED, driven by GPIO48.
3.3 V Power On Turns on when LED the USB power is connected to the board.
Note
Be sure to use an appropriate USB cable.
Some cables are for charging only and do not provide the needed data lines nor work for programming the boards.
Hardware
Setup
Connect the board with the computer using USB-to-UART Port. Connection using ESP32-S3 USB Port is not fully implemented in software. In subsequent steps, USB-to-UART Port will
be used by default.
Software
Setup
Please proceed to Get Started, where Section Installation Step by Step will quickly help you set up the development environment and then flash an application example onto your board.
Colour: Black
material: plastic
Package Contents:
1 x ESP32-S3-DevKitC-1 development board(N8)
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.