This productFor SPST single-pole single-throwHigh isolation PIN reflection type rf switch, can rapid on-off rf signal path.Small volume,High speed, low insertion loss, high isolation ratio.With no signal leakage circuit design, switch state changes, the control voltage will not impact the radio frequency part.Applies to 300 ~ 1 2700 MHZ frequency rangeW under low power communications equipment distribution of transceiver, antenna switch, switch frequency, etc.
Model: KSWP - 1 t
Range of working frequency: 300 ~2700 MHz
System impedance: 50 Ohms
When VSWR (switch) : ~2700 MHz
Conduction insertion loss: ~2200 MHz
< =="" 2.5="" db="" @="" 300="=" ""="" 2.5="" db="" @=""> ~2700 MHz
Isolation: > = 40 dB (0 control voltage ~0.5 Vdc)
> = 55 dB (control voltage - 5 VDC, @ 300 ~1000 MHz)
Switch time:
The maximum input power: 30 dBm (1 W)
Conduction mode control voltage: + 3.6 ~5.0 Vdc
Conduction mode control current: 7 ~9 mA @ 5 VDC
By the state control voltage: 0 ~0.5 Vdc
High isolation as the control voltage: - 5 Vdc @ 300 ~1000 MHz
Radio frequency port: SMA - F
The control voltage interface: 0.8 mm hard wear heart capacitor lead
The frequency response figure (frequency scanning range: 40-4000 MHZ.Yellow line reflection loss for radio frequency port, vertical scale: per 5 db;The blue line for conduction insertion loss) :
(frequency scanning range: 40-4000 MHZ.Green line for conduction insertion loss, the purple line is the control voltage to 5 v isolation, the blue line to control the voltage of 0 v isolation, vertical scale: each 10 db)
Installation dimensions: