Plastic Case ( no battery cell ) and Charging Protection Circuit Board For WORX 20V Li-ion Battery
It is only suitable for worx 20V Green 5 Pin Interface lithium batteries ( WA3593 WA3595 WA3596 WA3016 WA3027 WA3401 WA3406 WA3408), not suitable for batteries marked with "X" in the figure below :
///////////////////////////////////////////////////////////////
This product is component without battery core .
It is used to repair and assemble batteries pack,
only for people who are familiar with battery performance
and have practical experience in battery assembly.
///////////////////////////////////////////////////////////////
No Original, 100% Brand New, No Battery Cell !!!!!!
Please pay attention to the interface and size, it is not applicable to batteries with 4-pin or 6-pin interfaces in the figure below (marked with "X" in the figure below ) :
It can fill 10 pieces of 18650 li-ion batteries, but this is only a shell, there is no battery inside.
Preparation before assembly:
(1). If a new core is used, please note:
a. 18650 power lithium battery core must be selected,
b. A group of six cores must be equipped with resistance and capacitance to make their voltage the same.
(2). If the old battery is repaired, please test the voltage at both ends of each cell. If the voltage is different, please charge each cell to the same voltage value.
Very important:
Ensure that the voltage of each cell is the same before welding PCB.
1. " BOX "
Package include:
As shown in the picture below:
2. " PCB " Package include:
As shown in the picture below:
3. "BOX-PCB" Package include:
As shown in the picture below:
Note:
1. there are no batteries in the package !!!!!!
2. If you need batteries, please don`t place orders !
3. If you don`t have the knowledge of battery assembly, please don`t place an order !